Examine the compressor’s regulator setting and set the air pressure to 90 psi (6.2 bar). If the problem continues, take the machine apart and clean and lubricate the internal parts except for the jaws.Įnsure the compressor has the correct CFM rating for the air rivet gun. Ensure the air is at 90 psi (6.2 bar) and air lines are not tangled.Įxamine and fix the trigger or replace it.Ĭlear blockage by opening the air inlet and removing any debris.įlush rivet gun with gum solvent. Then lubricate all components except for the jaws.Įxamine the air compressor and air hoses. Issueĭirt and shavings accumulated in the jaws or jaw assembly cover.ĭisassemble the jaw assembly and clean each component. However, if a part needs replacement, check first with the air rivet gun’s manufacturer. Most fixes involve clearing debris from the airline, air cylinder, or jaw assemblage or applying lubrication where needed. The following table covers common issues pneumatic rivet guns encounter, what these issues may indicate, and how to fix them. It is unlikely the air cylinder will need relubrication during its lifetime, but this examination should still be a part of regular maintenance. Even if the air cylinder is initially lubricated, periodically inspect this area to check if the lubricant is still there or has worn off. Use a tool to push the piston down and apply lubricant to the inside of the cylinder. If this is not the case, unscrew the bottom cap of the air cylinder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |